How to Lay Roofing Shingles

how to lay roofing shingles

The first step in laying roofing shingles is preparing your roof. Start by measuring the width of the roof. Then cut a portion of the shingle so that it fits over the ridge. You can use felt paper to mark the line. Next, you need to nail each shingle evenly. Repeat this process with the remaining shingles. If you need to do partial shingling repairs, start at the far left or right of the roof.

Before installing the first row of shingles, you must mark the roof to be covered. If the shingle is larger than the rest of the roof, make sure the tabs are facing upward. You can use a special starter row for this purpose or a roll of strip material that is cut to the length of the roof. You can then turn the full-sized shingles so that the tabs face upward. For the second row, set the shingles back about half a tab so that they touch the tops of the cutout slots on the shingles below. If you are using a gable roof, you must cut the half tab off at the left edge.

Before laying the shingles, you need to clean up the area where you will be working. Cover any plants that are close to the house or move the yard furniture away from the house. Make sure you have good ventilation for the area and plan accordingly. When preparing your roof, you should always plan on 10% of the materials you purchased. Also, always remember that safety is the most important thing to consider when working on the roof. If you have a helping hand, you can make the process more efficient and save your body from any strain or injury.

The first row of shingles should overlap the previous row by about half an inch. Next, cut the top row of shingles six inches from the first one in the left corner. Then, lay the shingles to the edge of the roof and nail them down. Continue to do this step until the entire roof is covered. Once you have completed this step, you can start installing the next row of shingles. This process will require patience, and it can take a few days.

If you are planning to install roof shingles on your house, you need to prepare the valleys. Valleys are the area of the roof where two roof lines meet and form a rundown. These valleys can look like a virtual river! To avoid leaking, you can lay self-adhesive ice and water shield over these valleys. However, this method is not recommended for architectural-style shingles.

Before applying shingles to your roof, prepare the surface by installing an underlayment, an ice and water barrier, and drip edge. Remember to overlap the ice and water barrier and fold the drip edge over by an inch. After that, nail the last cap shingle. Apply roofing tar to the shingles. When you’ve completed the ridge cap shingles, the final step is to seal the seams and joints.