How to Install EPDM Roofing Yourself

There are two ways to install EPDM roofing: torch-on felt roofing and cold-applied EPDM. Both methods require specialized equipment and trained workers, and are subject to risks. To learn how to install EPDM roofing yourself, follow these easy steps. After adhering the membrane to the roof deck, it needs to be dried for a few days to ensure that there are no bubbles or wrinkles.

how to install epdm roofing

Before you begin the installation process, make sure to clean the surface of your building. It will help if you don’t have too many contaminants on the surface, since EPDM is not a handcrafted material. You can hire someone to help you with this, and the work will not be as complicated as you might imagine. Before you begin, be sure to take measurements and make a plan so that you can avoid making mistakes.

Once you have a plan, you can proceed to the next step. Once you have your building’s dimensions, measure the height and length of the EPDM sheet. You’ll need a little bit of extra room to lay it down. Be sure to broom the EPDM roof to ensure it lays flat and looks good. Once the roofing is level and ready for use, it’s time to install it on the roof.

Before you begin, make sure the surface is clean and free of contaminants. The EPDM sheet will arrive in a large sheet that will fit your building’s dimensions. Using a paint roller, spread the adhesive across the leading edge of the roof. When the adhesive has dried, roll the sheet forward while it’s still wet. You should be able to do this by yourself or with the help of a team.

After you have cleaned and prepared the surface of the roof, you should prepare the adhesive. The adhesive needs to be applied to the top part of the EPDM sheet. You should let the membrane dry for about 5 to 20 minutes before you start applying it to the rest of the roof. Then, you should apply the second adhesive to the lower half of the membrane. After applying the adhesive, you can proceed with the installation.

After you’ve finished cutting the EPDM sheet, you should place it over the plywood or OSB board. Once it’s flat, the membrane is ready for installation. After preparing the surface, you should apply the top layer of plywood or OSB board. If you’re putting up EPDM roofs, be sure to add insulation. If the top layer of the building is flat, the waterproofing will last longer.