If you’re planning on building a shed, one of the first questions that might come into your mind is how to install corrugated metal roofing on it. This roof is an excellent choice for many reasons. It will add aesthetic appeal and value to your structure. Before you get started, you’ll need to select the right metal panel to install on your shed. Once you’ve chosen your panel, you’ll have a beautiful new roof that will last you decades.
Once you’ve chosen the type of metal roofing you want to use, you’ll need to cut the sheets to fit. Straight edge snips are best for cutting aluminium and steel sheets. Place the sheets on a flat workbench surface and mark them using a pencil or a measuring tape. Once you have marked where you’re going to cut, measure along the cutting line to ensure you’ve taken the measurements correctly.
If you’re installing the roof yourself, make sure to measure the width of the opening you plan to put in the roof. Then, cut the second sheet of metal to fit exactly on top of the first. Then, lay it horizontally across the deck of the roof and secure it with roofing staples. Be sure to overlap the layers at least four inches. Once you’ve secured the first sheet, you can install the next layer.
Before you install the new metal roofing, make sure to remove the existing shingles and debris from the roof. After removing the shingles, you can position the building paper and plywood on the roof. Next, you can attach the first panel with 1/2-inch screws. Make sure to apply washers on the nails as you go. Overlap the sheets to ensure a weatherproofed roof.
The first step in putting corrugated metal roofing on a shed is to determine its height. Then, measure the length of the roof and the height of the opening. Then, mark the ridges with a utility knife. After the first layer, you can apply the second layer. Then, you’ll need to trim the remaining pieces of the roof. After the first layer, you’ll need to cover the other two layers.
After you have measured and cut the required size, the next step is to lay the first sheet of corrugated metal on the roof. Remember to leave a gap of 4 inches between the first and second sheet of metal. Then, you’ll need to install the second sheet of corrugated material on top of the first. After the first layer, you’ll need to drill the screws into the other two sheets.