How to Do Roofing Shingles

how to do roofing shingles

How to Do Roofing Shingles

One of the most important questions a home owner has when putting up a new roof is how to do roofing shingles. This DIY project is often easier than it appears, but it is still an important step that must be done correctly. Listed below are some of the tips to follow, from choosing the right kind of shingles to nailing them on the roof. By following these tips, you will be able to install the roofing shingles properly.

When laying shingles, use hook blades that will fit into a standard utility knife. Always remember to stagger the seams and make sure they are even when laying shingles. A standard reveals are between 5 and 6-1/2 inches and should be measured horizontally to ensure a level surface. You can also use a nail gun to apply a sealant between the shingles and the roofing materials. Once you’ve got all of these tips, you can begin laying shingles.

Start by nailing the first row of shingles on the roof. Make sure you have nails in the proper spots and do not hammer the shingle into the tar strip. The second row of nails should be 2 inches above the shingle. It should be placed on the other side of the shingle so that the nail heads will cover it. This way, you will have 8 nails holding each shingle.

Next, install the shingles. When nailing, be sure to place the nails at least six inches above the ridge of the roof. If there is a valley in your roof, you should start the shingle with the lower edge. The shingle should extend 12 inches from the ridge. Continue to do this until you have completed the entire roof. If you want to do this task on your own, there are a number of resources available to guide you.

To lay the shingles, you should first measure the length of the roof. If the roof is long enough, you can use a tar strip to guide you. After calculating the length of the roof, lay down the last row of shingles. Then, apply shingles with nails that will overlap. Then, you should put the ridge cap on the ridge. If the shingle is wide enough, you can attach it with the tabs.

To lay roofing shingles, you must first measure the sections of your roof and determine the number of shingles needed. If the shingles are wooden, you should use the right size. A right-handed person should work from the left. To install the shingles, you must also measure the section of your roof. Then, multiply the area of each section by three to get the correct number of bundles. It is also important to ensure that the shingles are evenly spaced across the roof.